Skullbeast - building a Cylon

YouTube · Post by **groupleaderzeta** » Thu Apr 28, 2011 8:25 am

Vary nice, great start. Can't wait to see them done.

YouTube · Post by **Cylon-Knight** » Thu Apr 28, 2011 8:43 am

Awesome Skullbeast! Are they made from a material that be chromed okay?

Post by **Skullbeast** » Thu Apr 28, 2011 10:20 am

Zeta thanks
Ck still the sculpt I have yet to mold anything.

YouTube · Post by **groupleaderzeta** » Thu Apr 28, 2011 10:31 am

Hey SB,
post pic of the inside of your helm, love to see the controller installed

GZ

Post by **Skullbeast** » Thu Apr 28, 2011 11:06 am

Zeta I can but it's all temporary, because I have to gut it to chrome.

Post by **Red Eye** » Thu Apr 28, 2011 11:13 am

Nice update!

Are you able to offer them fully painted as well?

Post by **Skullbeast** » Thu Apr 28, 2011 12:29 pm

Red eye we can make that a case by case, I would use a metal technique that is very believable. But the cost may go up a bit.

Post by **Red Eye** » Thu Apr 28, 2011 1:10 pm

That would be no problem!

Post by **GoldCylon** » Thu Apr 28, 2011 2:25 pm

I have something made in method called Cold Cast. Is that a method you can use? The item I have looks great.

YouTube · Post by **groupleaderzeta** » Thu Apr 28, 2011 2:35 pm

I was curious about how the controller fits in the mohawk.
You had mentioned that it don't fit flat after you resized the helmet.
I may be able upgrade the new controller boards to be smaller to fit better.

GZ

Post by **Skullbeast** » Thu Apr 28, 2011 2:57 pm

Sure zeta I can show that for you. I'll take some pics later.

Post by **GoldCylon** » Thu Apr 28, 2011 3:10 pm

groupleaderzeta wrote:I was curious about how the controller fits in the mohawk.
You had mentioned that it don't fit flat after you resized the helmet.
I may be able upgrade the new controller boards to be smaller to fit better.

GZ

Some one else mentioned to me that the board didn't fit correctly in the Mohawk either. I suspect your Cylon helmet Mohawk is wider in your build if that is what you used as a reference point to build the board.

Post by **Skullbeast** » Thu Apr 28, 2011 3:12 pm

My hyperdyne vortex 2 voice showed up today.

Cylon gold cold cast usually refers to porcelain powder added to plastic casting resin. I will just use the resin. They will look the same but resin in far easier to sand and drill.

YouTube · Post by **groupleaderzeta** » Thu Apr 28, 2011 4:55 pm

Could those that have purchased the zeta eye controller from me, Please let me know how the board fits?
This may become a issue, and would like to better understand it. For future release of the controllers may need to be changed.

Thanks to everyone.
CZ

Post by **Skullbeast** » Fri Apr 29, 2011 12:24 am

I have added some more pics to the last few, and fixed

one of the youtube vids.