Page 1 of 1
Chest piece
Posted: Fri Jan 06, 2006 3:13 pm
by GoldCylon
I was working of forming a master mold for the Master Chief chest, but the item Delight I used on the back section was out of stock. I used a clay based item, and well long story short it didn't work. I have now a small supply of Delight and will start working on the chest again.
Re: Chest piece
Posted: Sun Dec 06, 2009 8:44 am
by Cylon-Knight
*BIG BUMP*
GoldCylon - did you ever get your Master Chief project done? It's been about 3 years???
Re: Chest piece
Posted: Mon Dec 14, 2009 8:16 am
by GoldCylon
The project was shipped to a fellow board member in TX, and he tried about 2 years, and wasn't able to get good pulls off his, and my work. It is currently a dead project at this time.